HARVEST H1364XT Assembly Manual page 25

Step 34
Now, go through the carriage and tighten all the 5/8" flange bolts & 3/4" hex bolts.
Fig. 34.1 Fig. 34.2 Fig. 34.3
Step 35
Locate the 2 hydraulic cylinders (30093) & the 1-1/2" x 7-1/2" cylinder pins. Locate (4) 3/8" x 3" roll pins.
Using a lifting strap, lift the first cylinder up & orientate the cylinder so the rod end points away from the axle
and the bore or cylinder end is towards the axle. Also, make sure the cylinder ports are pointed down. Attach
the cylinder to the upper scissors assembly using the cylinder pin and the 2 roll pins as shown in fig. 35.1.
Repeat this step for the second cylinder.
Fig. 35.1
H13XT Assembly Manual Page 25 of 33