HARVEST H1364XT Assembly Manual page 32

Step 48
Next, install the upper transition flighting (30883) on the lower drive shaft attached to the swing tube flighting.
To do this, slide a 1/4" x 1" square key into key way on swing tube flighting shaft. Slide upper transition
flighting onto shaft aligning the key and keyway. To secure the transition flighting thread the set screw that is
5/16" x 1-1/4" into hole on knuckle (Fig. 48.1). After set screw is tightened, thread a 5/16" flange nut onto set
screw and tighten to lock set screw in place.
Step 49
Next, install the swing hopper onto the swing tube. Slide the hopper transition onto the swing tube while
inserting the square shaft of the upper transition flighting into the square tube on the lower transition flighting.
Align the holes in the hopper and swing tube with a punch. With the access door open secure the hopper to the
swing tube using (2) 5/8" x 1-1/2" flange bolts, (4) 5/8" washers, & (2) 5/8" top lock nuts. The washer will go
between the bolt and the hopper & the nut and swing tube respectively.
H13XT Assembly Manual
Fig. 48.1
Fig. 49.1
Page 32 of 33