HARVEST H1364XT Assembly Manual page 11

Step 14
Next, install the infeed tounge assembly to the infeed housing. Secure the tongue with a 3/4" x 6" hex bolt &
toplock nut through the rear of the infeed housing and the tounge tube. Next, lift the tongue up to the infeed
housing and insert a 3/4" x 6" hex bolt under the tounge in the from on the infeed housing. Secure the bolt and
tougue with a 3/4" toplock nut. Tighten all fasteners in this step.
Fig. 14.1
Step 15
Next slide the chain guard over the PTO shaft and secure to the infeed housing (2) 3/8" x 3/4" flange bolts &
flange nuts on the bottom and (2) 3/8" x ¾" flange bolts on the top. Then place lower "U" shaped guard place
onto guard and secure with (4) 3/8" x 3/4" flange bolts.
Fig. 15.1
H13XT Assembly Manual Page 11 of 33