Teldat Dm709-I User Manual page 60

7 Switch Configuration
VLAN config>enable
VLAN config>vlan 20 ethernet0/0 port 14
VLAN config>vlan 20 ethernet0/0 port 15
VLAN config>vlan 20 ethernet0/0 port 16
VLAN config>tag-insertion ethernet0/0 port 16
Example 3:
Configuring the mode for port 7 output queues service discipline to strict.
ethernet0/0 switch config>port 7 qos priority strict
ethernet0/0 switch config>
Example 4:
Configuring port 3 to use the DSCP field value in input IP packets for prioritization purposes.
ethernet0/0 switch config>port 3 qos trust dscp
ethernet0/0 switch config>
7.6.8.13 stp
Configures the parameters associated to the Spanning Tree protocol in a switch port. You can configure different
Spanning Tree instances in the switch so they operate independently. This is useful when executing Spanning Tree
through VLAN. There is an example of this under Examples.
Note
If, in the dynamic configuration, the Spanning Tree is enabled or disabled in a port, the Spanning Tree
sets machine reboots in all ports concerned.
Syntax:
ethernetX/X switch config>port <port-number> stp
<1..16>
edge-port Edge Port configuration
admin
auto
link-type
point-to-point
point-to-multipoint Configures the port as not connected to a point-to-point LAN
autodetect
path-cost
priority
bpdu-filter
enable
disable
bpdu-guard
enable
disable
edge-port
admin
auto
enable
instance
disable
link-type
point-to-point
point-to-multipoint
autodetect
path-cost
<0..200000000>
priority
<0..255>
54
spanning-tree instance
Configures the port as an edge port
Configures auto edge port detection
Link Type Configuration
Configures the port as connected to a point-to-point LAN
Automatic detection of a point-to-point LAN
Port Path Cost
<0..200000000> Port Path-cost
Port Priority for this stp instance
<0..255> Port Priority
don't send or receive BPDUs for this port
Enables BPDU filtering on this port
Disables BPDU filtering on this port
don't accept BPDUs on this port
Enables BPDU guard on this port
Disables BPDU guard on this port
Edge Port configuration
Configures the port as an edge port
Configures auto edge port detection
enables spanning-tree on this port
spanning-tree instance
<1..16> spanning-tree instance
disables spanning-tree on this port
Link Type Configuration
Configures the port as connected to a point-to-point LAN
Configures the port as not connected to a point-to-point LAN
Automatic detection of a point-to-point LAN
Port Path Cost
Port Path-cost
Port Priority
Port Priority
Teldat SA
LAN Interfaces