List; Llc; Lldp; Mac-Address - Teldat Dm709-I User Manual

3 Configuring Ethernet Interfaces
ethernetX/X config>ip-encapsulation <encapsulation type>
ethernetX/X config>ip-encapsulation ?
ethernet
ieee-802.3
ethernetX/X config>
Example:
ethernet0/0 config>ip-encapsulation ieee-802.3
ethernet0/0 config>

3.3.10 LIST

Displays the current configuration of the Ethernet interface. This includes the MAC address used by the interface, the
speed, the duplex mode and the IP encapsulation. Whenever the interface is configured using auto-negotiation, the
speed and the duplex mode are not displayed (as these are obtained from the characteristics of the devices connec-
ted to the Ethernet).
Syntax:
ethernetX/X config>list
Example 1:
ethernet0/0 config>list
MAC address: 000000000000
Speed: Auto-negotiation
IP encapsulation:
ethernet0/0 config>
Example 2:
ethernet0/0 config>list
MAC address: 000000000000
Speed: 100Mbps
Duplex mode : Half duplex
IP encapsulation:
ethernet0/0 config>

3.3.11 LLC

Accesses the LLC configuration. LLC configuration is mandatory to pass frames over the SNA network. See the LLC
Configuration Commands section for a description of the available commands and their use.
Syntax:
ethernetX/X config>llc
Example:
ethernet0/0 config>llc
-- LLC User Configuration --
ethernet0/0 LLC config>

3.3.12 LLDP

Configures the LLDP options in the interface. For further information on the Link Layer Discovery Protocol , please
see manual Teldat Dm813-I LLDP Protocol.

3.3.13 MAC-ADDRESS

The interface can adopt locally-administered addresses or those provided by the device manufacturer. Only locally-
administrated addresses are provided through this command. Entering 00-00-00-00-00-00 (default value) causes the
router to use the default factory station address. This last MAC address is used by default.
Syntax:
ethernetX/X config>mac-address <MAC address>
Example:
14
Ethernet type 8137
Ethernet 802.3 raw without 802.2
ETHER
ETHER
Teldat SA
LAN Interfaces