Cdp; Dot1Q; Dot1X - Teldat Dm709-I User Manual

3 Configuring Ethernet Interfaces
Syntax:
ethernetX/X config>auto-negotiation advertise
Example:
ethernet0/0 config>auto-negotiation
advertise
flow-control
asymmetric
symmetric
<cr>
no
flow-control
Command history:
Release
11.01.05

3.3.3 CDP

Configures the CDP protocol in the interface.

3.3.4 DOT1Q

Configures the Ethertype field for the tags used when encapsulation is executed at the MAC level that corresponds
to the IEEE 802.1Q standard in Ethernet subinterfaces. For further information on the encapsulation of Ethernet
subinterfaces, please see manual Teldat Dm750-I Ethernet Subinterface. The default value for this field is 0x8100.
Syntax:
ethernetX/X config>dot1q tunneling ethertype <ethertype>
ethernetX/X config>dot1q tunneling ethertype ?
0x88A8 dot1q tunneling etype 0x88A8
0x9100 dot1q tunneling etype 0x9100
0x9200 dot1q tunneling etype 0x9200
Example:
ethernet0/0 config>dot1q tunneling ethertype 0x88A8
ethernet0/0 config>
Note
Encapsulation increases the Ethernet frame and can cause MTU/fragmentation problems in some
devices. To solve this, limit the subinterface IP MTU using the IP MTU command described in manual
Teldat Dm702-I TCP-IP Configuration .

3.3.5 DOT1X

Accesses the 802.1X authentication configuration. For further information on 802.1X authentication, please see
manual Teldat Dm783-I 802.1X Authentication.
Note
The dot1x command is not available when the Ethernet interface is internally connected to a switch.
Syntax:
ethernetX/X config>dot1x
Example:
ethernet0/0 config>dot1x
-- 802.1X User Config --
ethernet0/0 dot1X config>
12
Autonegotiation advertisement configuration
Flow control capability
Asymmetric PAUSE toward link partner
Symmetric PAUSE
Disable capability advertisement
Flow control capability
Modification
This command was introduced as of version 11.01.05.
Teldat SA
LAN Interfaces