Promiscuous-Mode; Repeater-Switch; Speed - Teldat Dm709-I User Manual

Teldat SA
ethernet0/0 config>phy-shutdown

3.3.18 PROMISCUOUS-MODE

Enables promiscuous mode. In this mode, the Ethernet interface accepts all packets/frames transmitted on the me-
dia. However, when the promiscuous mode is disabled, the interface only accepts packets/frames addressed to it.
Syntax:
ethernetx/x config>promiscuous-mode
Default is disabled.
Example:
ethernet0/0 config>promiscuous-mode
ethernet0/0 config>
Command history:
Release
11.00.07
11.01.02

3.3.19 REPEATER-SWITCH

In Ethernet interfaces internally connected to a switch, access the switch configuration menu through this command.
You can configure the operating mode of each external port that belongs to the switch in this menu. For a more in-
depth explanation of the commands available, please see the Switch Configuration Commands section.
Syntax:
ethernetX/X config>repeater-switch
Example:
ethernet3/0 config>repeater-switch
-- Switch User Config --
ethernet0/0 switch config>

3.3.20 SPEED

Configures the interface speed: 10 Mbps, 100 Mbps or 1000Mbps (when supported by the device). If the device is
configured using auto-negotiation, the speed configuration is ignored. The interface is configured in accordance with
the characteristics of the devices connected to the Ethernet.
Syntax:
ethernetX/X config>speed <speed>
ethernetX/X config>speed ?
1000mbps
100mbps
10mbps
ethernetX/X config>
Example:
ethernet0/0 config>speed 100mbps
ethernet0/0 config>list
MAC address: 000000000000
Speed: 100 Mbps
Duplex mode : Half duplex
IP encapsulation:
ethernet0/0 config>speed 10mbps
ethernet0/0 config>list
MAC address: 000000000000
Speed: 10 Mbps
Duplex mode : Half duplex
IP encapsulation:
LAN Interfaces
Modification
This command was introduced as of version 11.00.07.
This command was introduced as of version 11.01.02.
forces 1000Mbps
forces 100Mbps
forces 10Mbps
ETHER
ETHER
3 Configuring Ethernet Interfaces
17