Applying The Fascia; Applying The Inner Door Decals - VKI Technologies Suprema Operation And Service Manual

SUPREMA - OPERATION & SERVICE MANUAL

Applying the Fascia

1. Apply the fascia to the Suprema front door.

Note:
Do not apply any
pressure to the
fascia until it is
placed in the proper
position. This way,
if it is not in the
right place, you can
carefully peel it off
and re-position it.

Applying the Inner Door Decals

1. Apply the "Care and Maintenance" decal.
2. Apply the "Diagram" decal.
Page 6 of 58
a) Peel the backing paper from the rear of the fascia (Figure 3).
b) Align the fascia inside the plastic trim around the selection panel, making certain
that the fascia does not interfere with the buttons.
c) Once aligned, press the fascia firmly in place (Figure 4).
Figure 3 – Remove Backing
a) Open the outer door.
b) Peel off the lower half of the backing paper.
c) Align the upper half of the decal with the right
side of the inner door.
d) When satisfied with the alignment, apply the
lower portion of the decal to the door surface.
e) Lift the upper portion of the decal and remove
the backing paper.
f) Apply pressure to the upper half of the decal,
from the center outwards.
a) Peel the backing from the decal.
b) Align the decal below the inner door grounds
deflector.
c) When satisfied with the alignment, apply
pressure to the decal.
Figure 4 – Install Fascia
02-2012
#8
#9
Suprema - Operation & Service