Outlet Valves - VKI Technologies Suprema Operation And Service Manual

SUPREMA - OPERATION & SERVICE MANUAL
Removing the Outlet Valves
1. Turn off the water supply to the machine.
2. Switch off the power to the machine.
3. Drain the water tank to a level below the valves.
a) Remove the top clip from the drain plug, then push it up to open.
4. Remove the valve cover.
a) Remove the screws that secure it in place.
5. Disconnect the wires from the valve you wish to remove.
a) Coffee valve wires are numbered #3 and #1-8. Hot water valve wires are numbered
6. Pull the valve(s) out towards you.
Installing the Outlet Valves
1. Immerse the valve seal support in warm water and insert it into the tank outlet
tube.
2. Insert the valve into the appropriate outlet of the hot water tank.
a) The top outlet is for chocolate, the center is for hot water and the lower is for
3. Re-connect the valve wires.
a) Coffee valve wires are numbered #3 and #1-8. Hot water valve wires are numbered
4. Attach the hoses.
a) The brown hose goes onto the coffee valve, the hose to the whipper goes onto the
5. Position the coffee hose (brown) into the brewer funnel.
6. Turn on the water supply to the machine, and switch the power on.
7. Check for leaks.
8. Allow the water tank to fill and test all valves.
9. Replace the valve cover.
Page 44 of 58
#2 and #1-7. Chocolate valve wires are numbered #4 and #1-6. The green ground
wires also need to be disconnected.
CAUTION:
Water coming out of the water tank may be extremely hot.
Use caution when removing the outlet valves
coffee water.
#2 and #1-7. Chocolate valve wires are numbered #4 and #1-6. The green ground
wires also need to be reconnected.
chocolate valve, and the other hose goes to the hot water valve.
02-2012
.
Suprema - Operation & Service