Product On/Off; Setting Products - VKI Technologies Suprema Operation And Service Manual

SUPREMA - OPERATION & SERVICE MANUAL
Reminder: The "
INCREASE
button, and the "
left of the "

Product ON/OFF

This feature allows you to run a complete coffee or hot chocolate cycle (including the two
pauses) without any product being dispensed (no coffee or chocolate). This will allow you to
manually test brew different coffee blends for the customer to taste. The customer can then
decide which blend he prefers. To use it as a test brew cycle, simply weigh and manually pour
the coffee grounds into the brew chamber, and press the "
repeated if you need to test brew another blend.
1. To switch the product
and scroll until the following message appears,

Note:
If the product is
switched " ", it
OFF
remains off until you
enter the " - "
SET UP
mode to switch it
" " again. Please
ON
make sure it is
switched " "
ON
before you leave the
account.

Setting Products

1. To adjust product settings, press the "
and scroll until the following message appears,

Note:
The minimum
allowable setting
for all products is
0.5 seconds, and
the maximum is
8.0 seconds.

Tip:
While in the "
SET
" or "
PRODUCT SET
" menus, you
WATER
can test the product
and water quantities
by pressing the
" " button. The
START
product or water
tested will correspond
to the LED's
illuminated on the
front selection panel.
Make certain you
have something ready
to catch the coffee
grounds or water that
will be dispensed.
Page 16 of 58
" (+) and "
DECREASE
MENU SCROLL UP
" button. See page 4 for illustration.
START
OFF
a) Press the " " button to enter set mode.
START
b) Switch the product "
Press the " " button to toggle it "
UP
c) To exit the "
PRODUCT
hidden " " or "
UP DOWN
a) Press the " " button to enter the set mode.
START
b) At this point, you can now select the product settings for any cup size, product and
product strength by pressing the appropriate buttons on the selection panel. The
time setting displayed will correspond to the LED's that are illuminated.
c) Using the hidden setting adjustment buttons, increase or decrease the timing for the
product.
d) To exit the "
SET PRODUCT
" " or " " scroll buttons.
UP DOWN
" (-) buttons are located to the right of the "
" and "
MENU SCROLL DOWN
, press the " " button on the hidden menu scroll buttons
UP
PRODUCT ON/OFF
PRESS <START>
" or " " by using the hidden setting adjustment buttons.
OFF ON
" or "
OFF ON
on-off" mode and proceed to the next setting, press the
" scroll buttons.
" button on the hidden menu scroll buttons
UP
SET PRODUCT
PRESS <START>
" mode and proceed to the next setting, press the hidden
02-2012
" buttons are located to the
" button. This procedure can be
START
".
Suprema - Operation & Service
"
START