Drain Valve - VKI Technologies Suprema Operation And Service Manual

SUPREMA - OPERATION & SERVICE MANUAL
Removing the Drain Valve
To remove the drain valve on a plastic water tank, it will be necessary to drain and completely
remove the tank from the coffee maker. The drain plug can only be removed from the interior
of the water tank.
1. Remove the water tank.
2. Remove the drain valve.
Installing the Drain Valve
1. Install the drain valve.

Note:
The center tube at
the bottom of the
tank is for the
water inlet hose
fitting, and the rear
.
tube is not used
Page 48 of 58
a) Refer to the "Removing the Water
WARNING:
To avoid severe burns, make absolutely certain that the
heater element is not hot before proceeding!
a) Remove the upper and lower clips on the drain plug.
b) Push drain plug upwards until it goes through the bottom of the tank (to the inside).
c) Remove the tank lid.
d) Reach inside the tank and remove drain plug.
a) Remove tank lid.
b) Add new o-rings to the drain valve.
c) From the top of the tank, push the drain valve through the bottom (front tube).
d) Install the clips. The smaller clip goes on the top slot, and the larger goes on the
bottom slot of the drain valve.
Tank" instructions in this manual.
02-2012 Suprema - Operation & Service