Fuse Box Assembly - VKI Technologies Suprema Operation And Service Manual

SUPREMA - OPERATION & SERVICE MANUAL
Removing the Fuse Box Assembly
1. Switch off the machine power and disconnect the service cord from the wall outlet.
2. Remove the brewer.
3. Remove the brewer bracket assembly.
4. Disconnect the wires identified in the table below.

Tip:
When the fuse box is
removed, make sure
you inspect the wiring
and the tabs inside
the box before re-
installing it.
5. Disconnect the ground wire attached to the left wall of the machine.
6. Remove the two screws securing the fuse box.
7. Lift and pull on the fuse box to remove it.
Installing the Fuse Box Assembly
1. From inside the cabinet, put the service cord through the fuse box location cutout in
2. Place the fuse box into position.
3. Align the holes on the fuse box with the holes on the cabinet wall.
4. Secure with two screws.
5. Connect the wires identified in the table below.
6. Connect the ground wire to the cabinet wall.
7. Replace the brewer bracket assembly.
8. Replace the brewer.
9. Plug in the service cord.
10. Switch the coffee maker "ON".
Page 52 of 58
WIRE
#3-2
on fuse box harness
#3-3
on fuse box harness
#5
on fuse box harness
#6-1
on fuse box harness
#7-1
on fuse box harness
#6-3
on fuse box harness
#7-3
on fuse box harness
#2
on fuse box harness
#11
on fuse box harness
the back of the cabinet.
WIRE
#3-2
on fuse box harness
#3-3
on fuse box harness
#5
on fuse box harness
#6-1
on fuse box harness
#7-1
on fuse box harness
#6-3
on fuse box harness
#7-3
on fuse box harness
#2
on fuse box harness
#11
on fuse box harness
*For more information about wiring, consult the
CONNECTED TO:
#11 on water tank harness
#12-3 on general harness
Ground stud on rear board cover
Inlet Valve
Inlet Valve
#6 on water tank harness
#1-2 on water tank harness
#10-1 on general harness
Stud #3 on heater relay
CONNECTED TO:
#11 on water tank harness
#12-3 on general harness
Ground stud on rear board cover
Inlet Valve
Inlet Valve
#6 on water tank harness
#1-2 on water tank harness
#10-1 on general harness
Stud #3 on heater relay
wiring section
02-2012
of this manual.
Suprema - Operation & Service