Inlet Valve; Water Tank Assembly - VKI Technologies Suprema Operation And Service Manual

SUPREMA - OPERATION & SERVICE MANUAL
Removing the Water Tank Assembly
1. Switch the coffee maker "OFF".
2. Drain the water tank.
a) Place a heat-resistant and leak-proof container beneath the water tank.
b) Remove the top clip on the drain plug and push the drain plug upwards. The bottom
3. Remove the brewer.
4. Disconnect the inlet hose.
a) Remove the hose clamp securing the inlet hose to the inlet fitting.
5. Remove the valve cover on the water tank.
6. Remove the hose from the hot water valve.
7. Remove the hose fitting from the whipper motor (if installed).
8. Disconnect the water tank harness from the rear board.
9. Disconnect the temperature probe harness from the rear board.
10. Disconnect the wires identified in the table below.
WIRE
#1-2
#8-1
#11-1
#6
#1-2
#11
#13-1
11. Carefully slide the water tank forward and out of the machine.
Suprema - Operation & Service
clip will act as a stopper.
CAUTION:
Water coming out of the water tank may be extremely hot. Use
caution when removing the outlet valves.
CONNECTED TO:
Whipper Motor
on General Harness
Whipper Motor
on General Harness
Wire #3-2 on Fuse Box Harness
on Tank Harness

Inlet Valve

on Tank Harness
Inlet Valve
on Tank Harness
Stud #3 on Heater Relay
on Fuse Box Harness
Ground Stud on Rear Board Cover
(ground wire)
*For more information about wiring, consult the wiring section
02-2012
of this manual.
Page 45 of 58