Heater Element - VKI Technologies Suprema Operation And Service Manual

SUPREMA - OPERATION & SERVICE MANUAL
Removing the Heater Element
1. Remove the water tank.
a) Refer to the
2. Remove the lid assembly.
a) Refer to the
3. Remove the two 11/16" brass nuts securing the heater element to the lid.
4. Remove the heater element.
5. Detach the thermal cut-off probe from the heater element.
a) Remove plate/clamp securing the thermal cut-off probe to the element.
Installing the Heater Element
1. Position the heater element into the tank lid.
a) The "curve" at the bottom of the heater element should point towards the rear of
2. Secure the element to the tank lid with the two 11/16" brass nuts.
3. Replace thermal shut-off plate/clamp and probe.
4. Replace the lid assembly.
a) Refer to the "Installing the Water Tank Lid" instructions in this manual.
5. Replace the water tank.
a) Refer to the
Suprema - Operation & Service
"Removing the Water
"Removing the Water Tank
WARNING:
To avoid severe burns, make absolutely certain that the
heater element is not hot before proceeding!
the tank.
"Installing the Water
Tank" instructions in this manual.
Lid" instructions in this manual.
Tank" instructions in this manual.
02-2012 Page 47 of 58