Coin Changer Installation; Installing The Coin Changer - VKI Technologies Suprema Operation And Service Manual

SUPREMA - OPERATION & SERVICE MANUAL

COIN CHANGER INSTALLATION

Installing the Coin Changer

To operate this equipment in "
installed. This changer can be purchased from your local Coinco retailer.
1. Switch the coffee maker "OFF" and open the inner door.

Note:
2. Loosen the three changer mounting screws on the inside of the front door.
The machine power
MUST be switched
OFF when
connecting or
disconnecting the
coin changer. Failure
3. Remove the 'Acceptor' unit from the coin changer.
to do so will damage
the coin changer and
the electronics in the
machine.
4. Set the changer to accept and reject certain
currencies and denominations of coins.
5. Slide the 'key-hole' slots of the changer onto
the mounting screws.
6. Partially fill the pay-out tubes with an appropriate amount of coins.
7. Reconnect the ribbon cable and re-install the 'Acceptor' unit.
8. Plug the changer into the receptacle on the inside top of the door.
9. Switch the coffee maker "ON".
Suprema - Operation & Service
COIN
a) Using a Phillips screwdriver, loosen (but do not remove) the three mounting
screws.
a) Lift the two locking tabs on top of the coin changer.
b) Pull the acceptor towards you. It will pivot, with the base portion remaining in
place.
c) Disconnect the ribbon cable and remove the acceptor.
a) Locate the DIP switches on the inside of
the coin changer and adjust them
accordingly. Consult the diagram below
for the function of each switch.
a) Having removed the acceptor, you will
see three 'key-hole' slots on the rear
wall of the changer. Align these slots
with the three mounting screws on the
inside of the door. It may be necessary to
hold the coin reject assembly (on inside
top of coffee maker) up and out of the
way.
b) Slide the changer down until the three
screws line up with the narrow part of
the 'key-hole' slots.
c) Tighten the three screws enough to
secure the changer. Do not over-tighten.
" mode, an optional Coinco 9300-series changer must be
02-2012 Page 57 of 58