Replacing Major Components; Brewer - VKI Technologies Suprema Operation And Service Manual

SUPREMA - OPERATION & SERVICE MANUAL

REPLACING MAJOR COMPONENTS

Removing the Brewer
1. Press the red "
a) The brewer motor will cycle and stop with the chamber in
2. Release the brewer lock pin.
a) Lower the lock pin by pulling it down all the way.
b) Turn the pin to the left until it is directly below the flange,
3. Remove the brewer from the brewer bracket.
a) Gently grasp the brewer with one hand on the top, and the
b) Pull the brewer towards you until it is free from the
Installing the Brewer
1. Press the red "
a) The brewer motor will cycle and stop in a position where it will accept the brewer
2. Place the brewer onto the brewer bracket.
a) Make sure that the brew chamber is open.
b) Gently grasp the brewer, with one hand on the top, and the other hand on the
c) Align the top edge of the brewer with the locating flanges on the brewer bracket.
d) Push the brewer into place to engage the brewer drive pin with the slot in the motor
3. Engage the lock pin.
a) Release the lock pin from under the front flange and engage it with the hole located
Suprema - Operation & Service
OPEN BREWER
the open position.
and release.
other hand on the bottom.
bracket.
OPEN BREWER
with the chamber open.
bottom.
One flange is at the left side of the bracket and the other is at the back of the
bracket.
coupling. If it does not align, move the brewer crank arm slightly until you feel the
brewer engaging with the motor coupling.
on the front left side of the brewer. The brewer should now be firmly in place.
02-2012
" button.
" button.
Brewer lock pin
Page 41 of 58