Removing Shipping Materials; Connections And Adjustments - VKI Technologies Suprema Operation And Service Manual

SUPREMA - OPERATION & SERVICE MANUAL

Removing Shipping Materials

1. Lift and place the coffee maker onto your workbench.
2. Open the outer and inner doors.
a) There are two sets of keys attached to an envelope on the service cord. The keys
3. Remove all the shipping tape.
a) Shipping tape is found in the following areas: Valve cover, Service cord, Brewer

Connections and Adjustments

When the water tank is drained after testing at the factory, it is possible for the element may
remain hot for a short while afterwards and trigger the thermal cut-off switch.
1. Reset the thermal cut-off switch.
a) Remove the valve cover (figure 1) on the front of the hot water tank.
b) Remove the plastic wing-nut securing the water tank access panel to the top of the
c) Remove the water tank access panel.
d) Press the "reset" button on the thermal cut-off switch (figure 2).
2. Re-install the water tank access panel, and the valve cover.
Suprema - Operation & Service
WARNING:
Never lift the machine by placing your hand underneath the
front door. It is not designed to support the weight of the machine, and
serious personal injury and/or damage to the unit may occur.
numbered 8625 are for the outer door. The keys numbered 8645 are for the inner
door.
spout, Cup Trays.
WARNING:
Do not connect the service cord to the wall outlet at this point
as more adjustments are still required to the machine.
machine.
Figure 1 - Remove valve cover.
Figure 2 - Reset the thermal cut-off switch.
02-2012 Page 5 of 58