To Resume The Set Speed - Fiat Fullback Single cab Owner's Manual

Type 2
307
The set speed driving is deactivated
automatically in any of the following
ways.
When you depress the clutch pedal
(on vehicles with M/T).
When your speed slows to
approximately 15 km/h or more below
the set speed because of a hill, etc.
When your speed slows to
approximately 40 km/h or less.
When the Electronic Stability Control
(ESC) starts operating (if so equipped).
Refer to "Electronic Stability Control
(ESC)".
243)
Also, the set speed driving may be
deactivated when the engine speed
rises and approaches the tachometer's
red zone (the red-coloured part of the
tachometer dial).
152)
188

To resume the set speed

If the set speed driving is deactivated
by the condition described in "To
deactivate", you can resume the
previously set speed by push up the
RES + switch (C) while driving at a
speed of approximately 40 km/h or
higher.
Type 1
AHA108438
308
Type 2
309
Under either of the following conditions,
however, using the switch does not
allow you to resume the previously set
speed. In these situations, repeat the
speed setting procedure:
The CRUISE CONTROL ON/OFF
switch is pressed.
The ignition switch is turned OFF or
the operation mode is put in OFF.
Indicator lamp go off.
WARNING
241) If the device is faulty, turn ring nut A to
O, check the condition of the fuse and
contact a Fiat Dealership.
242) When travelling with the device active,
never move the gear lever to neutral.
243) On vehicles equipped with A/T,
although the set speed driving will be
AA0110637
deactivated when shifting to the "N"
(NEUTRAL) position, never move the
selector lever to the "N" (NEUTRAL)
position while driving. You would have no
engine braking and could cause a serious
accident.
AHA108454