Switching Between 4Hl And 4Llc - Fiat Fullback Single cab Owner's Manual

Switching between 4HL and 4LLc

Drive
mode
Indicator lamp
selector
position
4HLc
Drive mode
switching
in progress
4LLc
and
Blink
Illuminate
Remain off
NOTE When the drive mode-selector is
set between "2H", "4H" and "4HLc",
the front wheel and/or centre differential
lock lamps blink while the selection is in
process. Take the following precautions
when the indicator lamp is blinking.
Keep the steering wheel in the
straight ahead position while making
range selections. If you attempt to drive
forward with the steering wheel turned,
gear rattling or shock may occur and
the desired range may not actually be
selected.
When the drive mode-selector is set
between "2H", "4H" and "4HLc", while
the vehicle is stopped, the front wheel
and
and/or centre differential lock lamps
blink while the selection is in process.
Drive slowly and normally after
confirming that the lamp is switched.
If the front wheel and/or centre
differential lock lamps blinking after a
"2H" <-> "4H" <-> "4HLc" selection
has been made with the vehicle
moving, hold the steering wheel in the
and
straight ahead position and slowly
depress the accelerator pedal several
times.
NOTE The front and the rear wheel
lamps will blink during shifting process
from "4HLc" to "4LLc" or vice versa, as
the transfer passes through the neutral
position. Be sure to operate the drive
mode-selector until the front and the
rear wheel lamps illuminate again.
NOTE When parking, apply the parking
brake before stopping the engine and
make sure that the front and the rear
wheel lamps and the low range lamp
are not blinking during shifting process
between "4HLc" <-> "4LLc".
Otherwise, the vehicle could
unexpectedly move even if the
automatic transmission is in the "P"
(PARK) position
NOTE If, after a "4HLc" <-> "4LLc"
selection has been made, front and the
rear wheel lamps continue blinking and
the desired range is not actually
selected, return the drive modeselector
to its previous position. Place the
steering wheel in the straight ahead
position, drive the vehicle forward, and
release the accelerator pedal. Next,
hold down the clutch pedal (with
manual transmission) or place the
selector lever in the "N" (NEUTRAL)
position (with automatic transmission)
and make the range selection again.
173