Too Hot Ldw Camera; Ldw Deactivation Due To Fault - Fiat Fullback Single cab Owner's Manual

NOTE The system stays in the "ON"
state for about 7 seconds after the
hazard lamp has stopped flashing or
the turn-signal lever has returned to the
home position.
Lane departure warning
A buzzer sounds intermittently and the
LDW lamp (amber) flashing when your
vehicle is about to leave or has left the
lane in the standby mode.
339
NOTE If warning continues for about
3 seconds or more, the system
switches to the standby mode before
the warning stops.
System problem warning
If a problem occurs with the system, a
visual warning specific to the type of the
problem is given.

Too hot LDW camera

If the system becomes temporarily
unable due to too high a temperature of
the LDW camera, the LDW system ON
indicator lamp illuminates.
If the camera cools down below the
predetermined temperature, the system
automatically recovers the normal state.
340
NOTE The LDW system ON indicator
AHA106405
lamp can be cleared temporarily by
setting the LDW switch to "OFF."

LDW deactivation due to fault

If LDW becomes to a non-initialized
state due to a fault, the LDW lamp
(amber) illuminates.
If this happens, please contact a Fiat
Dealership for inspection of the system.
341
154) 155) 156) 157)
248) 249) 250)
WARNING
AHA106375
248) In the case of indistinct, overlapping
or missing lane demarcation lines, the
system may not assist the driver: in this
case the Driving Advisor will be inactive.
249) The Driving Advisor is not an
automatic driving system and does not
replace the driver in controlling the
trajectory of the car. The driver is personally
responsible for maintaining a sufficient level
of attention to the traffic and road
conditions and for controlling the trajectory
of the car safely.
250) If the camera loses its position due to
a load variation, the system may not work
temporarily to allow the camera to perform
an autocalibration.
AHA106391
197