Super Select 4Wd Ii - Fiat Fullback Single cab Owner's Manual

131) Do not operate the drive
mode-selector while the rear wheels of the
vehicle are slipping on snow or ice.
132) If a problem is detected in the transfer
system, a safety device will activate. The
2WD/4WD operation indicator blinks (twice
per second), and transfer shifting will
become impossible. Park your vehicle in a
safe place, turn off the engine for a few
moments. Restart the engine. The lamp
should resume normal operation. If the
lamp continue to blink, have the vehicle
checked by a Fiat Dealership as soon as
possible.
SUPER SELECT 4WD
II
(where provided)
Shifting to rear-wheel drive or 4-wheel
drive can be made by operating the
drive mode-selector (A). Set the drive
mode-selector to an appropriate
position according to the road surface
conditions. In addition, the 2WD/4WD
operation indicator lamp and low-range
indicator lamp indicates the drive
mode-selector setting state. Refer to
"2WD/4WD operation indicator lamp
and low-range indicator lamp".
273
Drive mode-selector position and
2WD/4WD operation indicator lamp
Selector Indicator
position lamp
2H
Rear
wheel
drive
4H
Fulltime
4-
wheel
drive
4HLc
Centre
differential
lock
engaged
4-wheel
drive
4LLc
Low
range
AHA103635
centre
differential
lock and
engaged
4-wheel
drive
— Illuminate
— Remain off
133) 134)
Driving
conditions
When driving
on dry paved
road
The basic
position for
Super select
4WD II. When
driving on dry
paved or
slippery
roads.
When driving
on rough,
sand or snow
covered
roads.
When driving
up or down
steep hills, on
rough or
muddy roads
(especially
when
increased
torque is
required).
169