Fiat Fullback Single cab Owner's Manual page 220

Use the jacking point closest to the tyre
you wish to change.
389
A — Front jacking point
390
B — Rear jacking point
297) 298)
218
NOTE When jacking up the rear of the
vehicle, turn the tip of the jack so that
the grooved portion (C) properly meets
the designated point.
C
AHA105730
391
3. Using the jack handle, turn the
release valve (D) clockwise until it stops.
AHA105743
392
4. Insert the jack handle in the bracket
of the jack and hook the notch (E) on
the jack handle end to the claw (F) of
the bracket.
5. Move the jack handle up and down
to raise the ram until just before the jack
contacts the jacking point of the
vehicle. Ensure that the jack will
properly contact the vehicle jacking
point. Move the jack handle up and
down to raise the vehicle.
AHZ101102
393
NOTE This jack is a 2 stage expansion
type.
299) 300) 301) 302) 303) 304) 305) 306)
6. Remove the wheel nuts with the
wheel nut wrench, then take the wheel
off.
7. Clean out any mud, etc. on the hub
surface (G), hub bolts (H) or in the
installation holes (I) in the wheel, and
then mount the spare wheel.
AHA105756
307)
AHA105769