Start&Stop Monitor; Frozen Road Warning; Fuel Remaining Display; Engine Coolant Temperature Display - Fiat Fullback Single cab Owner's Manual

For information on how to change the
average fuel consumption display
setting, refer to "Changing the function
settings".
NOTE The average fuel consumption
display can be reset separately for the
auto reset mode and for the manual
reset mode.
NOTE "---" is displayed when the
average fuel consumption cannot be
measured.
NOTE The initial (default) setting is
"Auto reset mode".
NOTE The average fuel consumption
will depend on the driving conditions
(road conditions, how you drive, etc.).
The displayed fuel consumption may
vary from the actual fuel consumption.
Treat the fuel consumption displayed as
just a rough guideline.
NOTE The memory of the manual reset
mode or auto reset mode for the
average fuel consumption display is
erased if the battery is disconnected.
NOTE The display setting can be
changed to the preferred units {km/L,
L/100 km, mpg}. Refer to "Changing
the function settings".
Start&Stop monitor
The accumulated time the engine has
been stopped by Start&Stop system is
displayed. Refer to Start&Stop system.
NOTE When the ignition switch or the
operation mode is ON again, the
accumulated time will be reset.
Outside temperature display (if so
equipped)
This displays the temperature outside
the vehicle.
NOTE The display setting can be
changed to the preferred units (°C or
°F). Refer to "Changing the function
settings".
NOTE Depending on factors such as
the driving conditions, the displayed
temperature may vary from the actual
outside temperature.

Frozen road warning

If the outside air temperature drops
below approx. 3°C (37 °F), the alarm
sounds and the outside air temperature
warning symbol (A) flashes for about 10
seconds.
186
111)

Engine coolant temperature display

This indicates the engine coolant
temperature. If the coolant becomes
hot, will blink.
Pay careful attention to the engine
coolant temperature display while you
are driving.
112)

Fuel remaining display

The fuel remaining display indicates the
fuel level in the fuel tank when the
ignition switch or the operation mode is
ON.
187
1 — Full
0 — Empty
NOTE It may take several seconds to
stabilise the display after refilling the
tank.
AHA101295
AHA101309
93