To Remove The Spare Wheel; To Change A Tyre - Fiat Fullback Single cab Owner's Manual

To remove the spare wheel

1. Set the jack handle. (Club cab) (Refer
to "To use the jack handle (Club cab)".
2. Insert the jack handle (A) in the hole
(B) below the rear gate.
383
3. Securely insert the pin (C) on the jack
handle into the holder (D) of the spare
wheel carrier.
384
4. Insert the wheel nut wrench (E)
through the end of the jack handle hole
(F), and then turn it anticlockwise to
lower the spare wheel completely to the
ground and to slack the chain.
385
AHA102263
165)
5. Remove the hanger disc (G) from the
spare wheel.
386
AHA102276
NOTE Put the spare wheel under the
vehicle body near the flat tyre. This
makes it safer if the jack slips out of
position.
387
AHA102289

To change a tyre

1. Loosen the wheel nuts a quarter turn
with the wheel nut wrench. Do not
remove the wheel nuts yet.
388
AHA102292
2. Place the jack under one of the
jacking points shown in the illustration.
AHA102322
AHA102335
217