4 Wheel Drive Operation - Fiat Fullback Single cab Owner's Manual

139) Use the rear differential lock only as an
emergency measure when the vehicle is
stuck and cannot be freed with the drive
mode-selector in "4L" or "4H" position
(Easy select 4WD) or in "4LLc" or "4HLc"
position (Super select 4WD II). Deactivate
the rear differential lock immediately after
using it.
178
4 WHEEL DRIVE
OPERATION
By selecting 4-wheel drive, both axles
of the vehicle are rigidly connected with
each other. This improves the traction
characteristics. When turning sharp
corners or moving forward and
backward repeatedly, however, the
drive line is stressed, which is felt as a
braking effect. A 4-wheel drive vehicle
can accelerate more quickly and
smoothly.
However, note that the braking distance
is not shorter than that of a rear-wheel
drive vehicle.
When using 4-wheel drive on rough
roads (snow, mud, sand, etc.), it is
important to operate the vehicle
correctly.
NOTE The driving posture should be
more upright and closer to the wheel
than usual; adjust the seat to a good
position for easy steering and pedal
operation. Be sure to wear the seat
belt.
NOTE After driving on rough roads,
check each part of the vehicle and
wash it thoroughly with water. Refer to
"Vehicle care" and "Inspection and
maintenance following rough road
operation".
Driving on dry paved road and
highway
Select "2H" position (Easy select 4WD),
"2H" or "4H" position (Super select
4WD II) to drive on the dry paved road.
Especially on dry highway, never select
the "4H" or "4L" position (Easy select
4WD), "4HLc" or "4LLc" position (Super
select 4WD II).
140)
Driving on snowy or icy roads
Set the drive mode-selector to "4H"
position (Easy select 4WD), "4H" or
"4HLc" position in accordance with the
road conditions (Super select 4WD II)
and then gradually depress the
accelerator pedal for a smooth start.
Keep the pressure on the accelerator
pedal as constant as possible, and
drive at low speed.
NOTE The use of snow tyres and/or
tyre chains is recommended.
NOTE Maintain a safe distance
between vehicles, avoid sudden
braking, and use engine braking
(downshifting).
141)
Driving on sandy or muddy roads
Set the drive mode-selector to "4H" or
"4L" position (Easy select 4WD), "4HLc"
or "4LLc" position (Super select 4WD II)
and then gradually depress the
accelerator pedal for a smooth start.
Keep the pressure on the accelerator