How To Operate Ldw - Fiat Fullback Single cab Owner's Manual

How to operate LDW

The indication changes as follows
depending on the state of the system.
Turning on the system
When you set the ignition switch or
operation mode to "ON", the LDW
system ON indicator lamp appears,
showing that the system is placed in
the 'ON state'.
336
Turning off the system
When you press the LDW switch, the
LDW system ON indicator lamp goes
out, showing that the system is placed
in the 'OFF state'. Press the switch
again, the system returns to "ON".
196
337
NOTE When you set the ignition switch
or operation mode to "OFF" with the
system "OFF," the system will be
restored "ON." ("LDW 1" mode) You
can also select the "LDW 2" mode
which makes always the LDW system
in 'OFF state'.
1. Press the LDW switch, and the
system is placed in the 'OFF state'.
AHA106375
2. Press and hold the LDW switch for
more than approximately 10 seconds. A
buzzer sounds, and switch to the "LDW
2" mode.
3. Press the LDW switch, and the LDW
system ON indicator lamp goes out.
To return to the "LDW 1" mode, put the
system in 'OFF state', press and hold
the LDW switch for more than
approximately 10 seconds. A buzzer
sounds, and switch to the "LDW 1"
mode.
Standby state
In the standby mode, the system is
capable of recognizing the lane in which
your vehicle is positioned and issuing
audible warning when your vehicle goes
out of the lane.
The system automatically shifts from
the 'ON state' to the 'standby state' if
all of the following conditions are
simultaneously met. The LDW system
ON indicator lamp change to the LDW
AHA106388
standby indicator lamp (green).
The vehicle speed is approximately
65 km/h or higher.
The turn-signal lever is not operated.
The hazard lamp is not activated.
The brake pedal is not depressed.
Environmental conditions are
adequate for the system to recognize
the lane markings on both sides.
The system has been placed in the
'ON state'.
338
AHA106391