Mounting And Commissioning 3 - Siemens SIPROTEC 7UT613 series Manual

Preface
Purpose of this
Manual
Target Audience
Applicability of this
Manual
Indication of Con-
formity
Further Standards
7UT613/63x Manual
C53000-G1176-C160-2
This manual describes the functions, operation, installation, and commissioning of the
7UT613/63x devices. In particular, one will find:
• Information regarding the configuration of the device and descriptions of device
functions and settings → Chapter 2;
• Instruction for mounting and commissioning → Chapter 3,
• List of technical data → Chapter 4;
• As well as a compilation of the most significant data for experienced users → Ap-
pendix A.
General information about design, configuration, and operation of SIPROTEC 4
devices are laid down in the SIPROTEC 4 System Description /1/.
Protection engineers, commissioning engineers, personnel concerned with adjust-
ment, checking, and service of selective protective equipment, automatic and control
facilities, and personnel of electrical facilities and power plants.
This manual is valid for: SIPROTEC 4 Differential Protection 7UT613/63x; firmware
version V4.60.
This product complies with the directive of the Council of the European Commu-
nities on the approximation of the laws of the Member States relating to electro-
magnetic compatibility (EMC Council Directive 89/336/EEC) and concerning elec-
trical equipment for use within specified voltage limits (Low-voltage directive 73/23
EEC).
This conformity has been proved by tests conducted by Siemens AG in accor-
dance with Article 10 of the Council Directive in agreement with the generic stan-
dards EN 61000-6-2 and EN 61000-6-4 (for EMC directive) and the standard
EN 60255-6 (for low-voltage directive).
This device was designed and produced for industrial use.
The product conforms to the international standards of the series IEC 60255 and
the German standard VDE 0435.
IEEE Std C37.90-*
This product is UL-certified according to the Technical Data:
3