To Adjust The M10 Jewel Machine On The X,Y Axis For An Outside Engraving Of A Bracelet - GRAVOGRAPH M10 JEWEL User Manual

To adjust the M10 JEWEL machine on the Y,X axis for an outside engraving of a bracelet
To adjust the machine in Y,X you need to transfer a job of an outside
engraving on the reference bracelet (D11) provided with the machine :
1. Transfer the outside engraving composition of the bracelet
to the M10 JEWEL machine using the key (Launch).
Positionnement du bracelet de référence (D11) :
(See the description of the assembly in "Positioning a thin bracelet onto the
jaws and Outside Engraving" page 35).
2. Place the 3 ring/bracelet jaws (D3) in yellow position-outside
engraving as indicated on the opposite picture.
3. Fasten the reference bracelet (D11) using the jaws of the
chuck.
4. Install the diamond tip holder for outside engraving (D10)
with the diamond tip (D7) in the location (E) over the chuck.
5. Press the
of a bracelet.
The diamond holder moves to detect each limit switch and then stop in the reference point position.
6. Lower the diamond tip (D7) using the screw (V4) until it
touches slightly the reference bracelet.
The diamond tip must be in the middle of the width (on the Y axis) of the
reference bracelet (D11), which is 10mm.
7. Have a look to check that the diamond tip is well in
the middle of the width (in Y). If it is not the case,
move the diamond tip along the Y axis using the
and keys to correct it.
For a more precise adjustment, push on
or keys to turn the bracelet, and then
to mark it. Then check that the engraving
position is in the middle of the reference
bracelet's width. The Y position value
indicated on the PC's screen (G) can also
help you to have a very precise adjustment.
8. Replace the directional arrow (J3) vertically and pointing
downwards using the
9. Save the position of the zero point on the Y,X axis by pressing the
The diamond tip returns to the origin. The new reference point in Y,X for outside engraving of a bracelet is memorized
by the machine.
First Contact
keys simultaneously to select the Y,X machine adjustment for outside engraving
and keys.
Reference bracelet (D11)
Width = 10 mm
Outside diameter = 80 mm
key.
M10 JEWEL Machine - Electronic Engraving Machine . 45