Positioning A Ring Onto The Jaws And Outside Engraving - GRAVOGRAPH M10 JEWEL User Manual

Positioning a ring onto the jaws and Outside Engraving

1. Place the 3 ring/outside engraving jaws (D9) onto the chuck (1) and (2)
(the white arrows (F2) must be apart from the zone of tightening).
2. Mark the middle of the text length to be engraved on the Outside of the ring :
3. Place the ring so that the mark is at the bottom and is aligned with the directional arrow (J3).
4. Using the tightening ring (K) of the chuck, fasten the ring firmly in place so it will remain
immobile during engraving.
Proper fastening contributes towards reducing machine noise and vibrations during engraving.
Check that the object is properly fastened so it does not pop out during engraving and
that no object poses an obstacle to the movable parts' movements.
5. Touch (START) on the control panel of the machine and follow the instructions indicated on
the screen of the computer:
M10 JEWEL Machine - Electronic Engraving Machine . 32
Outside Engraving
Middle of the text
length
Outside diameter
1/3
First Contact