GRAVOGRAPH M10 JEWEL User Manual page 33

6. Remove any tool which can be present in the center of the chuck : Loosen
the 2 screws (V1) (in the center of the chuck) slightly. Turn the tool at
90° in the clockwise direction (1) and remove the tool (2).
7. Touch (START) to continue
8. Open the trapdoor of the location (E) above the chuck and Loosen the 2 screws (V3) slightly.
If necessary, replace the diamond tip (D7) by the diamond tip (D8) on the diamond tip holder
for outside engraving and tighten (V4).
First Contact
M10 JEWEL Machine - Electronic Engraving Machine . 33
2/3