Positioning A Wide Bracelet Onto The Jaws And Inside Engraving - GRAVOGRAPH M10 JEWEL User Manual

Positioning a wide bracelet onto the jaws and Inside Engraving

1. Place the 3 ring/bracelet jaws (D3) in position (the white arrows (F2)
must be in the chuck center in the zone of tightening) onto the chuck, (1)
and (2), and then position the green marks to the chuck center (3).
2. Mark the middle of the text length to be engraved on the Inside of the bracelet
3. Place the bracelet so that the mark is at the bottom and is aligned with the directional arrow
(J3).
4. Using the tightening ring (K) of the chuck, fasten the bracelet firmly in place so it will remain
immobile during engraving
Proper fastening contributes towards reducing machine noise and vibrations during engraving.
Check that the object is properly fastened so it does not pop out during engraving and
that no object poses an obstacle to the movable parts' movements.
5. Touch (START) on the control panel of the machine and follow the instructions indicated on
the screen of the computer:
M10 JEWEL Machine - Electronic Engraving Machine . 28
Inside Engraving
Inside diameter
Middle of the text
length
1/3
First Contact