GRAVOGRAPH M10 JEWEL User Manual page 30

11. Touch (START) on the control panel of the machine, to start the engraving.
For your own personal safety and to avoid any risks of being crushed by the machine
during engraving, do not stand near the tools.
In the event of a problem, touch
The machine will momentarily pause.
To continue with the rest of the engraving, touch
To stop engraving completely, touch one of the arrows of the joystick.
Engraving is finished, when the machine is ready to
receive a new file:
You can remove the bracelet, or launch again the engraving process
for a better result.
M10 JEWEL Machine - Electronic Engraving Machine . 30
(PAUSE) to stop the engraving process
(START)
3/3
First Contact