Engraving - GRAVOGRAPH M10 JEWEL User Manual

Engraving

You have just created a composition with your engraving software.
1. Switch on the machine and wait a few seconds.
The machine is ready to receive a file as indicated by the computer :
You can choose between inside engraving and outside engraving and between bracelet and
ring (1) . Use "Layout Wizard", the engraving assistant of GravoStyle 7 :
2. In the engraving programme, make sure that you have indicated the good engraving parameters,
the good machine parameters, the Z speed and the engraving orientation :
3. transfer the composition to the M10 JEWEL machine using the key (Launch).
First Contact
M10 JEWEL Machine - Electronic Engraving Machine . 19