To Adjust The M10 Jewel Machine On The X,Y Axis For An Inside Engraving Of A Ring - GRAVOGRAPH M10 JEWEL User Manual

To adjust the M10 JEWEL machine on the Y,X axis for an inside engraving of a ring
To adjust the machine in Y,X you need to transfer a job of an inside
engraving on the reference ring (D6) provided with the machine.
1. Transfer the inside engraving composition of the ring to the
M10 JEWEL machine using the key (Launch).
Positioning the reference ring (D6) :
(See the description of the assembly in "Positioning a thin ring onto the jaws
and Inside Engraving" page 21).
2. Place the 3 ring/bracelet jaws (D3) in red position-inside
engraving as indicated on the opposite picture.
3. Fasten the reference ring (D6) using the jaws of the chuck.
4. Install the diamond tip (D1) for inside engraving to the
chuck center.
5. Press the
of a ring.
The diamond holder moves to detect each limit switch and then stop in the reference point position.
6. Push on of the joystick (H) and then
on to lower the diamond tip (D1) until
it touches slightly the reference ring.
Push again on
The diamond tip must be in the middle of the width
(on the Y axis) of the reference ring (D6), which is
3mm.
7. Have a look to check that the diamond tip is well in the
middle of the width (in Y). If it is not the case, move the
diamond tip along the Y axis using the
correct it.
For a more precise adjustment, push on
or keys to turn the ring, and then to
mark it. Then check that the engraving
position is in the middle of the reference
ring's width. The Y position value indica-
ted on the PC's screen (G) can also help
you to have a very precise adjustment.
8. Replace the directional arrow (J3) vertically and pointing
downwards using the
9. Save the position of the zero point on the Y,X axis by pressing the
The diamond tip returns to the origin. The new reference point in Y,X for inside engraving of a ring is memorized by the
machine.
M10 JEWEL Machine - Electronic Engraving Machine . 42
keys simultaneously to select the Y,X machine adjustment for inside engraving
of the joystick (H).
and keys.
and keys to
Reference ring (D6)
Width = 3 mm
Inside diameter = 21 mm
key.
First Contact