To Adjust The M10 Jewel On The Z Axis - GRAVOGRAPH M10 JEWEL User Manual

To adjust the M10 JEWEL machine on the Z axis
To adjust the machine in Z you need to transfer a job of an inside
engraving on the reference ring (D6) provided with the machine.
1. Transfer the inside engraving composition of the ring to the
M10 JEWEL machine using the key (Launch).
Positioning the reference ring (D6) :
(See the description of the assembly in "Positioning a thin ring onto the
jaws and Inside Engraving" page 21).
2. Place the 3 ring/bracelet jaws (D3) in red position-inside
engraving as indicated on the opposite picture.
3. Fasten the reference ring (D6) using the jaws of the chuck.
4. Install the diamond tip (D1) for inside engraving to the
chuck center.
5. Press the
Y,X machine adjustment for inside engraving of a
ring.
The diamond holder moves to detect each limit switch and then
stop in the reference point in Y,X position.
6. Validate .
7. Press the
Z machine adjustment.
8. Have a look to check that the diamond tip is lightly into
contact with the reference ring. If it is not the case, move
the diamond tip along the Z axis using the
to correct it.
Adjust with a wedge of 0,05 mm or use the Z position value indicated on
the PC's screen (G) which can help you to have a very precise adjustment.
9. Save the position of the zero point on the Z axis by pressing the
The diamond tip returns to the origin. The new reference point in Z is memorized by the machine.
M10 JEWEL Machine - Electronic Engraving Machine . 46
keys simultaneously to select the
keys simultaneously to select the
and keys
0.05 mm
Reference ring (D6)
Width = 3 mm
Inside diameter = 21 mm
key.
First Contact