Brother DCP-J4110DW Service Manual page 306

(5) Press the Mono Start key.
The "Export to Card" appears again on the LCD.
(6) Press the Mono Start key.
The "Please wait" appears on the LCD.
Note: Never remove the external memory from the machine when exporting is in progress.
Note: If this procedure has been started with the user-access, the machine returns to the
standby state after showing the "Please wait" on the LCD.
(7) Wait for the machine to automatically return to the initial stage of the maintenance mode
and show "**** Active" on the LCD.
Remove the external memory from the machine and keep it in a safe place.
NOTE: If any of the error messages listed below appears, press the Stop key, and the machine
returns to the initial stage of the maintenance mode.
Error Message
Card is used
Insert Card
No file
Card Error
Machine ID Error
Write Error
Restoration Procedure
(1) Insert the external memory containing the backup data into the slot of the machine in the
initial stage of the maintenance mode.
The "**** Active" appears on the LCD. ("****" shows the name of the external memory
inserted.)
Note: Do not insert more than one external memory at a time.
Note: If the serial number in the backup data stored in the external memory does not match
that of the machine, data restoration cannot be performed.
(2) Press the 4 and 6 keys in this order.
The "Export to Card" appears on the LCD.
(3) Press the or
"Import from Card" for restoring only user setting information
"Import all" for restoring all backup data including machine information
The external memory is being used by another operation.
No external memory is inserted.
File name is invalid or no "BROTHER" folder exists.
External memory failure.
Mismatch of serial numbers between the machine and the
backup data (which is detected only in data restoration).
Insufficient free space in external memory.
key until the desired item, any of the following, appears on the LCD.
5-27
Cause
Confidential