Emerson Fisher 4320 Instruction Manual page 17

Instruction Manual
D103392X012
2. Install the mounting bracket on the actuator.
3. Attach the wireless position monitor to the mounting bracket using the 4 mounting bolts, as shown in figure 13.
4. Check for clearance between the magnet assembly and the positioner feedback slot.
5. Once the instrument is mounted perform the local interface calibration procedure, as described on page 22. Verify
that the magnet assembly is centered throughout the entire rotating range.
Figure 12. Housing and Mounting for Linear and
Quarter‐Turn Actuators
NOTE: ANY OF THE MOUNTING HOLES
MAY BE USED FOR LINEAR ACTUATORS
W9636‐2
Figure 14. Mounting—Rotary Magnet Assembly
MOUNTING INSERT FACES
GE42123 Rev A
OPTIONAL
MOUNTING HOLES
MOUNTING HOLES FOR
ROTARY NAMUR, M6
MAGNET
ASSEMBLY
Figure 13. For Rotary‐Shaft Actuators (Typical
Mounting Bracket)
ROTARY
MOUNTING
BRACKET
W9637‐2
MOUNTING
INSERT
FACES
19.5 $ 0.8
(0.77 $ 0.03)
BASE OF HOUSING
mm
(INCH)
4320 Position Monitor
February 2013
17