Ip Address] Screen; Routing Function - Icom SB-110 Instruction Manual

PDF取説-E_1 02.1.23 10:28 ページ53

5-3 [IP address] Screen

■ Routing function

[RRemarks]
If the routing mode is
used in the Access
Point mode, any wire-
less terminal cannot be
used for roaming be-
cause every device
(SB-110) has its own
unique network
dress.
■ Conceptual Diagram
Item to be set when connecting every communicating
network through a different IP address of the network
section.
Specify whether a routing function between a wired LAN
and wireless LAN is enabled or disabled (default setting:
No, i.e., disable).
Available protocol is TCP/IP only.
To enable the changed setting, you need to restart SB-110.
If the routing mode is used, traffic of unnecessary broad-
cast can be minimized when communication is made.
* When you select "No", you can set the IP address of the
same network section between the wired LAN and wire-
ad-
less LAN.
* When you select "Yes", you can set the IP address of a
different network section between the wired LAN and
wireless LAN.
An upper part of the diagram shows an example of the ad-
dress of each network when routing is not used. A lower
part of the diagram shows an example of the address of
each network when routing is used.
No (Disable): 192.168.0.0
Yes (Enable): 192.168.0.0
SETTING SCREEN
No (Disable): 192.168.0.0
Yes (Enable): 192.168.1.0
No (Disable): 192.168.0.0
Yes (Enable): 192.168.2.0
5
5
53