Icom SB-110 Instruction Manual page 21

PDF取説-E_1 02.1.23 10:28 ページ9
INSTALLATION AND CONNECTION
This chapter describes how to install SB-110 and how to connect it to the pe-
ripheral devices.
2-1. Installing on Mast ..............................................................................10
■ How to Install Elevation Angle Bracket .............................................10
2-2. Fixing on Wall .................................................................................11
2-3. How to Connect ..............................................................................12
2-4. Before Connecting Existing LAN .........................................................13
■ Checking Network Status ...............................................................13
■ Setting IP Address ........................................................................13
■ Connecting to Existing LAN ............................................................13
【 Remarks】
◎ Do not paint the case of SB-110. Otherwise, the radio wave is attenuated by metal
composition contained in the paint and SB-110 cannot show the performance fully.
◎ Fix the power cable connected to SB-110 and any other connecting cables to a
suitable position where nobody can touch.
【 Installation Work】
When you install SB-110, we assume no responsibility for any building breakage, any
damage resulting from a drop of SB-110 from a high place or unstable site or resulting
from any personal injury nor any accident in any other cases. If SB-110 is must be
installed at such high place or unstable site, be sure to consult an expert engineer.
CHAPTER 2