C Use Utility - Icom SB-110 Instruction Manual

PDF取説-E_1 02.1.23 10:28 ページ73
6-5 Returning Setting to Default State (continued from the previous page)

C Use Utility

Utility is contained in the CD-ROM of SB-110. This section describes the procedure to
initialize the settings with Utility.
◆ Before using Utility ◆
To return the SB-110 settings to the default state with Utility, enter the [Use utility] mode.
Otherwise, you cannot use Utility to initialize the settings. You need to access SB-110
and assign the IP address to your PC in advance.
<How to enter [Use utility] mode>
This section describes the procedure to enter the [Use utility] mode using the [MODE] but-
ton. You may also enter the [Use utility] mode through the [Administration] screen
( see 5-5).
1. Remove the power supply from SB-110.
2. Remove all the network devices from SB-110.
3. Connect an AC adapter to SB-110 holding down the [MODE] button and turn on the
power supply.
4. Release the [MODE] button before the [PWR] indicator and [MODE] indicator, which
were blinking (in green) alternately, start blinking (in green) simultaneously.
¡Enter the [Use utility] mode and start an operation.
<How to initialize>
1. Check that SB-110 is operating in the [Use utility] mode. Then, connect a PC to SB-110
through cable or by wireless and start the operating system.
2. Start [SB-110 Utility].
For how to start it, refer to "To Start Utility" in the "CD-ROM of SB-110" ( see 6-1).
¡The operation screen of Utility is shown. (Refer to the screen at the next page.)
3. Click the [User Data Initialization] radio button.
Enter the IP address of SB-110 in the [SB-110 IP address] text box and click [Start].
4. When the message "User data initialization has been completed." has been displayed
on the [SB-110 Utility] screen, the initialization of SB-110 ends.
[Use utility] mode
When the [Use utility] mode is enabled by operating the [MODE] button, the wireless LAN se-
curity setting (WEP function) of SB-110 is disabled temporarily until Utility operation has been
completed actually. If Utility is used in a wireless terminal, disable the WEP function of a PC.
MAINTENANCE
6
6
73