Returning Setting To Default State; A Use The [Mode] Button - Icom SB-110 Instruction Manual

PDF取説-E_1 02.1.23 10:28 ページ70
6
MAINTENANCE

6-5 Returning Setting to Default State

When you want renew the setting to change the network configuration or you want to
delete all the existing setting data, you can return the entire setting to the default state (ini-
tialize) in the three ways below:

A Use the [MODE] button.

B Use the setting screen ( see page 72).
C Use Utility ( see page 73).
* To return the setting to the default state with Utility, you need to start Utility in the CD-
ROM which comes with SB-110. For how to start it, refer to "To Start Utility" in the "CD-
ROM of SB-110" ( see 6-1).
A Use the [MODE] button.
When the initialization is executed in this way, all the setting items are returned to the de-
fault state. If the IP address set in SB-110 is unknown or the SB-110 setting screen can-
not be shown, you can perform the initialization according to the procedure below:
<How to initialize>
1. Remove the power supply from SB-110.
2. Remove all the network devices from SB-110.
3. Connect an AC adapter to SB-110 holding down the [MODE] button and turn on the
power supply.
4. Release the [MODE] button when the [PWR] indicator and [MODE] indicator, which
were blinking (in green) alternately, has started blinking (in green) simultaneously.
¡Enter the [INITIALIZATION] mode and start an operation.
5. Connect a PC to SB-110 through cable ( see 4-1) and start the operating system.
6. Start a WWW browser and specify the default IP address (192.168.0.1) of SB-110.
[INITIALIZATION] mode
When the [INITIALIZATION] mode is enabled by operating the [MODE] button, the IP address
and ESS ID of SB-110 are replaced with the default state temporarily until the initialization
(the procedure after the step 7 above) has been completed actually. If you turn on the power
supply of SB-110 without performing the procedure after the step 7, the setting is returned to
the default state.
70