Icom SB-110 Instruction Manual page 10

PDF取説-E_1 02.1.23 10:28 ページix
SAFETY PRECAUTIONS
■ SB-110 (continued from the previous page)
R Caution
◎ Do not disassemble SB-110.
Otherwise, you may be injured or get
an electric shock, SB-110 may become
out of order or the radio disturbance
may occur.
◎ Do not perform the installation work
at an unstable site.
Otherwise, you may fall to the ground
or may be injured.
◎ Do not drop the device or give a
considerable shock to it.
Otherwise, you may be injured or SB-
110 may become out of order.
◎ Do not use SB-110 near the TV set or
radio.
Otherwise, the radio disturbance may
occur in SB-110, TV set or radio.
◎ Do not expose SB-110 to the direct
sunlight, the air from the air
conditioner or any unsuitable places
where the temperature varies
considerably.
Otherwise, SB-110 may be deformed or
discolored, a it may catch fire or SB-
110 may become out of order.
◎ Follow instructions on manuals and
make right connections described in
this manual. Do not make a mistake
in connection to SB-110.
Otherwise, Unrecoverable permanent
damage may occur.
◎ If SB-110 is not used for a long time,
remove the AC adapter from SB-110
for safety.
Otherwise, SB-110 may overheat,
catch fire or become out of order.
ix
Failure to observe the precautions listed here could result in
personal injury or property damage.
◎ Do not put SB-110 on any unstable
place where is shaky or not level.
Otherwise, SB-110 may drop and
become out of order or you may fall to
the ground and may be injured.
◎ Do not use any unsuitable material
of which strength is insufficient
(antenna mast, bracket, etc.) or
corrosive material.
Otherwise, SB-110 may drop and become
out of order or you may be injured.
◎ Do not use SB-110 in the site where
strong magnetic fields or static elec-
tricity is generated or where is ex-
posed to the temperature or humidity
exceeding the specifications pre-
scribed in the instruction manual.
Otherwise, Unrecoverable permanent
damage may occur.
◎ When it thunders, remove the AC
adapter from the outlet to stop
operation. Do not Install, service,
connect or disconnect cables.
Otherwise, a it may catch fire or you
may get an electric shock.
◎ Do not use paint thinner or solvent
to clean SB-110.
Otherwise, the case material may
degrade and the paint may peel.
Usually, clean SB-110 with a soft cloth.
If the case is stained considerably, wipe
the case using a cloth dampened with
detergent that has been diluted with
water.