Static Route - Icom SB-110 Instruction Manual

PDF取説-E_1 02.1.23 10:28 ページ61
5-4 [Routing function] Screen (continued from the previous page)

■ Static Route

q Path .....................
w
Destination............
e
Subnet mask .........
r
Gateway ...............
t
Metric ..................
SETTING SCREEN
Routing table to define a relay path of packet inten-
tionally. A maximum of 20 items can be registered.
* When you have entered data, click [Add] to check that
the data has been registered in the [Current setting]
field. The details of registered data are displayed also in
the [IP Routing Information] screen.
q w e
¡ local: Shown when the [No] radio button of [Routing
function] is checked. This means that routing in-
formation to be registered is at the LAN side.
¡ ethernet: Shown when the [Yes] radio button of [Routing
function] is checked. This means that routing in-
formation to be registered is a wired LAN.
¡ wireless: Shown when the [Yes] radio button of [Routing
function] is checked. This means that routing in-
formation to be registered is a wireless LAN.
According to a selected path (local/ethernet/wireless), spec-
ify the IP address of the target party.
According to a selected path (local/ethernet/wireless), spec-
ify the net mask to the IP address of the target party.
Enter a gateway of packet transfer destination (router or ac-
cess point) to be routed.
Specify the number of routers and access points (or gate-
ways) on the route through which a packet is sent to the
other party. Enter a value in a range between 0 and 15. It
is presumed that transmission capacity of a line with a
smaller value is high.
5
r t
61
5