Table of Contents
Advertisement
PDF取説-E_1 02.1.23 10:28 ページ74
6
MAINTENANCE
6-5 Returning Setting to Default State (continued from the previous page)
<How to initialize> (An operation of the step 3)
1.
Click
2.
Enter
3.
Click
[R Remarks]
Do not quit Utility nor turn off SB-110 during the execution of Utility. Otherwise, data may be
lost or an error may occur in an operation. Wait until "... has been completed." is shown.
6-6 Upgrading SB-110
Use Utility contained in the CD-ROM of SB-110. This section describes the procedure to
upgrade SB-110 (firmware) with Utility.
■ Firmware
The firmware is a program written into flash memory of SB-110 by default. This program
may be upgraded to extend the function or improve the performance. Before upgrading it,
access the SB-110 setting screen and check the version information displayed in the frame
as shown below. A function can be added and SB-110 can be kept in the best condition.
Version Information
74
Advertisement
Chapters
Table of Contents
