Front Axle; Disassemble - Taylor-Dunn B0-150-00 Service And Replacement Parts Manual

Front Axle

DISASSEMBLE

WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
Disassembling and reassembling involves removing and replacing the left and right steering knuckles and king pin
bushings. Refer to the following sections for information regarding these procedures:
Replace the Steering Knuckle
Replace the King Pins and Bushings
NOTE: The front axle does not have to be removed unless the axle beam must be replaced. Refer to Front Axle
Removal and Installation for information regarding removing the front axle.
Page 30
B0-150-00 and MX-016-00
MB-150-03