Taylor-Dunn B0-150-00 Service And Replacement Parts Manual page 41

B0-015-00 and MX-016-00
12: Using a soft metal or hard wood dowel, drive
the intermediate shaft through the bearing just
enough to allow clearance for an ID bearing
puller. Do not attempt to drive the shaft out of the
opposite end of the transmission.
13: Remove the intermediate bearing with an ID
bearing puller.
14: While supporting the shaft and gear assembly,
repeat steps #12 and #13 for the opposite side
bearing and remove the intermediate shaft from
the housing.
15: Remove the o-rings from each end of the
intermediate shaft.
MB-150-03
16: Remove the circlip from the input shaft.
17: Remove the input shaft from the housing.
18: Press the bearings off of the input shaft.
19: Remove the o-rings from both sides of the
intermediate shaft bore and the input shaft bore
and discard the o-rings.
Drive Axle
Page 41