Brakes
MASTER CYLINDER
WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
There are no internally serviceable components in the
master cylinder. If the master cylinder is faulty, it must
be replaced
Add Fluid
1: Thoroughly clean the area around the master
cylinder cap and remove the cap.
2: Add brake fluid from a new sealed container to
the master cylinder until it as the maximum level
line molded in the reservoir.
Level lines are highlighted in the illustration for
clarity. They are not black.
SERVICE LIMITS
Description
Disc brake Pad minimum lining
Front rotor minimum thickness
Rear rotor minimum thickness
Rotor runout (front/Rear)
Page 64
Imperial
Metric
00625 inch
1.58 millimeter
0.200 inch
5.08 millimeter
0.200 inch
5.08 millimeter
0.005 inch
0.127 millimeter
HARDWARE TORQUE
If hardware is not listed here, refer to standard torque
values in the appendix.
Description
Brake Body Bolts
C0-425-48
Foot Pounds
Newton Meters
11
14.9
MC-425-13