Taylor-Dunn C0-425-48 Service And Replacement Parts Manual page 22

Tool List
TOOL LIST
The tools shown here are generic for servicing Taylor-Dunn
vehicles. Not all tools will be required for servicing this vehicle.
62-027-32: Throttle Module Analyzer
Tests the throttle module in or out of the
vehicle
Molex # 11-300-02: Pin Removing Tool
Removes 0.062 diameter pins from Molex
rectangular harness connectors. Not
available from Taylor-Dunn. Purchase from
any local electronics distributor.
77-200-00: Hydrometer
Used for testing battery electrolyte.
Illustration is of a typical hydrometer, actual
hydrometer type may vary.
Page 22
75-089-00: Throttle Module Test Harness
Used in conjunction with a volt meter to test
the throttle module. The module must be
installed in a working control system.
Note: Part # 62-027-31 includes instructions
Molex # 11-300-06: Pin Removing Tool
Removes 0.093 diameter pins from Molex
rectangular harness connectors. Not
available from Taylor-Dunn. Purchase from
any local electronics distributor.
77-201-00: Battery Filler
Used to safely add water to batteries.
Equipped with splash guard and auto-
shutoff when cell is full.
C0-425-48
62-027-00: Test Light
Used for testing electrical circuits. Switchable
for 12, 24, 36, 48 volt systems.
Required to complete troubleshooting
provided in the vehicle service manuals.
75-442-55: Pin Removing Tool
Removes pins from Molex Mini-Fit harness
connectors.
70-440-55: Pin Removing Tool
Removes pin from Amp circular harness
connectors.
MC-425-13