Error - Cause - Remedy; Pop-Up Message - vacuubrand VACUU-SELECT Instructions For Use Manual

Error – Cause –
Remedy
20901059_EN_VACUU·SELECT_V1.3_280119
8.2 Error – Cause – Remedy
8.2.1 Pop‑up message
Error ` Possible cause
Communica‑ One or more
`
`
VACUU·BUS compo‑
tion error
nents were removed.
Error at Address incorrectly
`
`
configured.
frequency
converter (FC)
Temperature too
`
`
high.
FC defective.
`
`
Error at control Valve defective.
`
`
system
Error at pump Check VMS‑B
`
`
(switching device).
Error at digital No power supply at
`
`
I/O module IN of I/O module.
Plug pulled out.
`
`
An error occurred in
`
`
the system and the
I/O module relayed it
to the controller.
Error at analog No power supply.
`
`
I/O module
Error at Ambient temperature
`
`
too high, Peltronic
Peltronic
overheated.
Performance require‑
`
`
ments too high.
Peltronic defective.
`
`
Error at vacu‑ Vacuum sensor
`
`
defective.
um sensor
Overpressure Pressure too high.
`
`
Measuring range
`
`
exceeded.
Underrange Pressure below mea‑
`
`
suring range.
Vacuum sensor
`
`
adjustment incorrect.
Troubleshooting
Remedy
Deactivate relevant
 `
VACUU·BUS com‑
ponents.
Perform component
 `
detection.
Configure correct
 `
address.
Replace defective
 `
component.
Check address.
 `
Replace defective
 `
component.
Send in defective
 `
device.
Connect power sup‑
 `
ply.
Check plug‑in con‑
 `
nection.
Remedy cause of
 `
external error.
Connect power sup‑
 `
ply.
Eliminate cause of
 `
overheating of the
Peltronic.
Send in defective
 `
component.
Replace defective
 `
component.
Send in defective
 `
component.
Acknowledge warn‑
 `
ing indication.
Eliminate cause of
 `
overpressure.
Calibrate vacuum
 `
sensor correctly.
Personnel
Specialist
Resp. spe-
cialist
Specialist
Resp.
specialist
Specialist,
resp.
specialist
Specialist
Specialist
Resp.
specialist
Operator,
specialist
Specialist
75