Varec 2920 Installation And Operation Manual page 80

2920 Float & Tape Transmitter
70
AdvHighLevel
CritHighLevel
LDeadband
Manual Level
CritLowTemp
AdvLowTemp
AdvHighTemp
CritHighTemp
TDeadband
ManTemp
TempOffset
All Params
5 Display and Configuration Interface
This value indicates the point at which the High Alarm
Level should be activated. When the incoming value
rises above this point the alarm is activated and de-
activated when the value is below this point.
This value indicates the point at which the Critical High
Level alarm should be activated. When the incoming
value rises above this point the alarm is activated and
de-activated when the value is below this point.
Manual level allows the user to enter a manual level
value, if the Level Reference is undefined.
This value indicates the point at which the Critical Low
Temperature alarm should be activated. When the
incomming value falls below this point the alarm is
activated and de-activated when the value is above this
point.
This value indicates the point at which the Low Alarm
Temperature should be activated. When the incoming
value falls below this point the alarm is activated and
de-activated when the value is above this point.
This value indicates the point at which the High Alarm
Temperature should be activated. When the incoming
value rises above this point the alarm is activated and
de-activated when the value is below this point.
This value indicates the point at which the Critical High
Temperature alarm should be activated. When the
incoming value rises above this point the alarm is
activated and de-activated when the value is below this
point.
A floating-point value used to determine change in
temperature alarm state. The temperature value must
be above Low Temp set points and below high Temp set
points by this amount for the alarm condition to clear.
The parameter must be set in current Temp units.
A floating-point value representing a manual
temperature value. This parameter is valid if the
Temperature Reference is undefined.
A floating point value to add a linear (positive or
negative) offset to the measured temperature value.
Lists all Display and Config Params in a list.
Installation and Operations Manual